ASTM D6181源自石油的矿物绝缘油中混浊度测量的标准试验方法

ASTM D6181 Standard Test Method for Measurement of Turbidity in Mineral Insulating Oil of Petroleum Origin
ASTM D6181源自石油的矿物绝缘油中混浊度测量的标准试验方法

This test method uses a ratio turbidimetric optical system to measure the turbidity of insulating oils relative to turbidity standards. Cloudiness or turbidity is attributed to matter whose diameter is approximately 20 % of the wavelength of the incident light. Increasing turbidity signifies increasing transformer fluid contamination, either from external sources or internal chemical reactions (such as oxidation) that produce fine particulate matter. Other turbidity sources, such as water droplets or gas bubbles, are not of interest in this evaluation of insulating oils. The elimination of these interferences is described in 6.2 and 6.6. This test method quantifies changes which may not be apparent to the unaided human eye.

1. Scope
1.1 This test method covers the laboratory procedure that ascertains the quantity of suspensions in insulating oils of petroleum origin using a nephelometric measurement technique to determine the fluid's turbidity. This test method is designed to reveal changes that may occur to these oils.
1.2 This test method is applicable for turbidities in the range of 0.1 to 500 Nephelometric Turbidity Units (NTU).
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately)
ASTM Standards
ASTM D923 Test Method for Sampling Electrical Insulating Liquids
ASTM D1533 Test Methods for Water in Insulating Liquids (Karl Fischer Reaction Method)
ASTM D1698 Test Method for Sediments and Soluble Sludge in Service Aged Insulating Oils
ASTM D1889 Test Method for Turbidity of Water
ASTM D4652 Specification for Silicone Fluid Used for Electrical Insulation
ASTM D5180 Test Method for Quantitative Test for Turbidity in Clear Liquids
ASTM E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods
Index Terms
insulating oil; oxidation; sludge; stability; turbidity

更多防火阻燃测试认证，请咨询中国防火网
电话：400-666-7290
网址：www.firete.com
邮箱：info@firete.com

...

 來源：防火網　發布時間：11/14/2013 點擊次數：1264