ASTM F1893测量半导体器件电离剂量率熔蚀指南

ASTM F1893 Guide for Measurement of Ionizing Dose-Rate Survivability and Burnout of Semiconductor Devices
ASTM F1893 测量半导体器件电离剂量率熔蚀指南

The use of FXR or LINAC radiation sources for the determination of high dose-rate burnout in semiconductor devices is addressed in this guide. The goal of this guide is to provide a systematic approach to testing semiconductor devices for burnout or survivability.
The different types of failure modes that are possible are defined and discussed in this guide. Specifically, failure can be defined by a change in device parameters, or by a catastrophic failure of the device.
This guide can be used to determine if a device survives (that is, continues to operate and function within the specified performance parameters) when irradiated to a predetermined dose-rate level; or, the guide can be used to determine the dose-rate burnout failure level (that is, the minimum dose rate at which burnout failure occurs). However, since this latter test is destructive, the minimum dose-rate burnout failure level must be determined statistically.

1. Scope
1.1 This guide defines the detailed requirements for testing semiconductor devices for short-pulse high dose-rate ionization-induced survivability and burnout failure. The test facility shall be capable of providing the necessary dose rates to perform the measurements. Typically, large flash X-ray (FXR) machines operated in the photon mode, or FXR e-beam facilities are utilized because of their high dose-rate capabilities. Electron Linear Accelerators (LINACs) may be used if the dose rate is sufficient. Two modes of test are described: (1) A survivability test, and (2) A burnout failure level test.
1.2 The values stated in International System of Units (SI) are to be regarded as standard. No other units of measurement are included in this standard.

2. Referenced Documents (purchase separately)
ASTM Standards
ASTM E170 Terminology Relating to Radiation Measurements and Dosimetry
ASTM E668 Practice for Application of Thermoluminescence-Dosimetry (TLD) Systems for Determining Absorbed Dose in Radiation-Hardness Testing of Electronic Devices
ASTM E1894 Guide for Selecting Dosimetry Systems for Application in Pulsed X-Ray Sources
ASTM F526 Test Method for Measuring Dose for Use in Linear Accelerator Pulsed Radiation Effects Tests
Index Terms
burnout; failure; high dose-rate; integrated circuits; ionizing radiation; latchup; microcircuits; semiconductor devices; survivability;

更多防火阻燃测试认证，请咨询中国防火网
电话：400-666-7290
网址：www.firete.com
邮箱：info@firete.com

...

 來源：防火網　發布時間：12/5/2013 點擊次數：1011