IEC 60695-2-13灼热/发热丝的测试方法材料的灼热丝起燃性测试

IEC 60695-2-13：火灾危险测试第2-13部分:基于灼热/发热丝的测试方法材料的灼热丝起燃性测试
IEC 60695-2-13：Fire Hazard Testing - Part 2-13: Glowing/Hot-Wire Based Test Methods - Glow-WIre Ignitability Test Method for Materials

Abstract摘要
This part of IEC 60695 specifies the details of the glow-wire test to be applied to test specimens of solid electrical insulating materials or other solid materials for ignitability testing to determine the glow-wire ignition temperature (GWIT).

The GWIT is the temperature which is 25 K (or 30 K) higher than the maximum test temperature, determined during this standardized procedure, at which the tested material

a) does not ignite, or
b) if sustained and continuous flaming combustion does not occur for a time longer than 5 s for any single flame event and the specimen is not totally consumed.

This test is a materials test carried out on a series of standard test specimens. The data obtained, along with data from the glow-wire flammability index (GWFI) test method for materials, IEC 60695-2-12, can then be used in a preselection process in accordance with IEC 60695-1-30 to judge the ability of materials to meet the requirements of IEC 60695-2-11.

NOTE As an outcome of conducting a fire hazard assessment, an appropriate series of preselection flammability and ignition tests may allow a reduction of end product testing.

更多防火阻燃测试认证，请咨询中国防火网
电话：400-666-7290
网址：www.firete.com
邮箱：info@firete.com

...

 來源：防火網　發布時間：1/6/2014 點擊次數：2993