ASTM C726 Standard Specification for Mineral Wool Roof Insulation Board ASTM C726 屋面用矿物纤维绝缘板标准规范
This specification covers the composition and physical properties of mineral wool insulation board used above structural roof decks as a base for built-up roofing and single ply membrane systems in building construction. The use of thermal insulation materials covered by this specification may be regulated by building codes or other agencies that address fire performance, or both. Specimens shall be sampled, prepared, tested, and conform accordingly to the following physical properties: compressive resistance, tensile strength, breaking load strength, water absorption, response to thermal and humid aging, linear dimensional change, thermal resistance, surface burning characteristics, and dimensions. This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope 1.1 This specification covers the composition and physical properties of mineral wool insulation board used above structural roof decks in building construction. The mineral wool roof insulation acts as a base for systems such as single-ply, polymer-modified bitumen and built-up roof. This specification also covers mineral wool insulation boards that incorporate a fibrous high density upper layer on the top surface 1.2 It is possible that the use of thermal insulation materials covered by this specification will be regulated by building codes or other agencies that address fire performance, or both. The fire performance of the material needs to be addressed through standard fire test methods established by the appropriate governing documents. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of the regulatory limitations prior to use.
2. Referenced Documents (purchase separately) ASTM Standards ASTM C165 Test Method for Measuring Compressive Properties of Thermal Insulations ASTM C168 Terminology Relating to Thermal Insulation ASTM C177 Test Method for Steady-State Heat Flux Measurements and Thermal Transmission Properties by Means of the Guarded-Hot-Plate Apparatus ASTM C203 Test Methods for Breaking Load and Flexural Properties of Block-Type Thermal Insulation ASTM C209 Test Methods for Cellulosic Fiber Insulating Board ASTM C390 Practice for Sampling and Acceptance of Thermal Insulation Lots ASTM C518 Test Method for Steady-State Thermal Transmission Properties by Means of the Heat Flow Meter Apparatus ASTM C1363 Test Method for Thermal Performance of Building Materials and Envelope Assemblies by Means of a Hot Box Apparatus ASTM D312 Specification for Asphalt Used in Roofing ASTM D450 Specification for Coal-Tar Pitch Used in Roofing, Dampproofing, and Waterproofing ASTM D2126 Test Method for Response of Rigid Cellular Plastics to Thermal and Humid Aging ASTM E84 Test Method for Surface Burning Characteristics of Building Materials Other Referenced Documents CAN/ULC-S102 Standard Method of Test for Surface Burning Characteristics of Building Materials and Assemblies Index Terms board; insulation; mineral wool; roof: Block and board thermal insulation--specifications; Insulating board; Mineral fiber insulation--specifications; Roofing materials/applications--specifications; Roof insulation--specifications; Thermal insulating materials--specifications;
更多防火阻燃测试认证,请咨询中国防火网 电话:400-666-7290 网址:www.firete.com 邮箱:info@firete.com
... |