ASTM D3014硬质热固性泡沫塑料在垂直状态时火焰高度、燃烧时间和质量损失的标准试验方法

ASTM D3014 Standard Test Method for Flame Height, Time of Burning, and Loss of Mass of Rigid Thermoset Cellular Plastics in a Vertical Position
ASTM D3014  硬质热固性泡沫塑料在垂直状态时火焰高度、燃烧时间和质量损失的标准试验方法

Tests made on rigid cellular materials in accordance with the conditions described by this test method can be of considerable value in comparing their burning characteristics.
This test method has been applied to flexible cellular materials and other plastics, but no detailed studies have been conducted to determine its general applicability to these materials.
In this procedure, the specimens are subjected to one or more specific sets of laboratory test conditions. If different test conditions are substituted or the end-use conditions are changed, it is not always possible by or from this test to predict changes in the fire-test-response characteristics measured. The results are therefore valid only for the fire-test-exposure conditions described in this procedure.

1. Scope
1.1 This is a fire-test-response standard. This test method covers a small-scale laboratory screening procedure for comparing relative extent and time of burning and loss of mass of rigid thermoset cellular plastics. This test method is to be used solely to establish relative burning characteristics and shall not be considered or used as a fire-hazard classification.
1.1.1 This test method shall not be used for materials that drip or melt under the test conditions.
1.2 During the course of combustion, gases or vapors, or both, are evolved which are potentially hazardous to personnel. Adequate precautions shall be taken to protect the operator.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. A specific precautionary statement is given in 1.2.
1.4 This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of materials, products, or assemblies under actual fire conditions.
1.5 Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests.
Note 1—There is no known ISO equivalent to this standard.

2. Referenced Documents (purchase separately)
ASTM Standards
ASTM D883 Terminology Relating to Plastics
ASTM D1622 Test Method for Apparent Density of Rigid Cellular Plastics
ASTM D5025 Specification for Laboratory Burner Used for Small-Scale Burning Tests on Plastic Materials
ASTM E176 Terminology of Fire Standards
ASTM E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
Index Terms
cellular plastics; flame height; flammability; mass loss; time of burning; vertical position; Burning characteristics--plastics; Fire testing--plastics; Flame height; Flammability--plastics; Mass loss testing; Rigid cellular plastics; Time to burn; Vertical position/testing

更多防火阻燃测试认证，请咨询中国防火网
电话：400-666-7290
网址：www.firete.com
邮箱：info@firete.com

...

 来源：防火网　发布时间：12/18/2013 点击次数：1304