ASTM E1232化学药剂可燃性温度极限的试验方法

ASTM E1232  Standard Test Method for Temperature Limit of Flammability of Chemicals
ASTM E1232 化学药剂可燃性温度极限的试验方法

1. Scope
1.1 This test method covers the determination of the minimum temperature at which vapors in equilibrium with a liquid (or solid) chemical will be sufficiently concentrated to form flammable mixtures in air at atmospheric pressure. This test method is written specifically for determination of the temperature limit of flammability of systems using air as the source of oxidant and diluent. It may also be used for other oxidant/diluent combinations, including air plus diluent mixtures; however, no oxidant/diluent combination stronger than air should be used. Also, no unstable chemical capable of explosive decomposition reactions should be tested (see 8.3).
1.2 This test method is designed and written to be run at local ambient pressure and is limited to a maximum initial pressure of 1 atm abs. It may also be used for reduced pressures with the practical lower pressure limit being approximately 13.3 kPa (100 mm Hg). The maximum practical operating temperature of this equipment is approximately 150 °C (302 °F) (Note A1.2).
1.3 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are provided for information only.
1.4 This standard should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions, and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard of a particular end use.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific safety precautions are given in Section 8.

2. Referenced Documents (purchase separately)
ASTM Standards
ASTM D3278 Test Methods for Flash Point of Liquids by Small Scale Closed-Cup Apparatus
ASTM D3828 Test Methods for Flash Point by Small Scale Closed Cup Tester
ASTM D3941 Test Method for Flash Point by the Equilibrium Method With a Closed-Cup Apparatus
ASTM E220 Test Method for Calibration of Thermocouples By Comparison Techniques
ASTM E230 Specification and Temperature-Electromotive Force (EMF) Tables for Standardized Thermocouples
ASTM E502 Test Method for Selection and Use of ASTM Standards for the Determination of Flash Point of Chemicals by Closed Cup Methods
ASTM E537 Test Method for The Thermal Stability Of Chemicals By Differential Scanning Calorimetry
ASTM E681 Test Method for Concentration Limits of Flammability of Chemicals (Vapors and Gases)
ASTM E698 Test Method for Arrhenius Kinetic Constants for Thermally Unstable Materials Using Differential Scanning Calorimetry and the Flynn/Wall/Ozawa Method

ANSI Standard
ANSI-MC96.1 Temperature Measurement Thermocouples

NFPA Standard
Index Terms
temperature; flammability; air; oxidant; equipment;

更多防火阻燃测试认证，请咨询中国防火网
电话：400-666-7290
网址：www.firete.com
邮箱：info@firete.com

...

 来源：防火网　发布时间：11/7/2013 点击次数：1987